Coordinate  -  Split Table  (MM->2->7->1)

This menu implements NTCIP 2.5.9 SPLIT TABLE. The Ver 50/60 controller provides a maximum of 24 split tables. Ver 61 provides a maximum of 32 splits (2.5.8 MAXIMUM SPLITS).  The split number in this table is a "read-only" entry (shown in red) and corresponds with 2.5.9.1 SPLIT NUMBER.

Split Times are programmed in seconds as per 2.5.9.3 SPLIT TIME PARAMETER.

The Coordinated Phase (Coor-Ø) is selected with an "X" value and conforms with 2.5.9.5 SPLIT COORDINATED PHASE.

The Split Mode (2.5.9.4 SPLIT MODE PARAMETER) is implemented as follows.  Note that recalls are in effect whenever the Split Table is called by the active Pattern Table - whether the controller is running coordination or free operation.:

• NON - (none) no split mode control or recalls are active for the phase; however, any recall programmed under MM->1->1->2 is still active

• MIN - (minimumVehicleRecall) min recall applies to this phase when the split table is active (overrides all recalls programmed under MM->1->1->2)

• MAX - (maximumVehicleRecall) max recall applies to this phase when the split table is active (overrides all recalls programmed under MM->1->1->2)

• PED - (pedestrianRecall) ped recall set for this phase when the split table is active (overrides all recalls programmed under MM->1->1->2)

• MxP - (maximumVehicleAndPedestrianRecall) max + ped recalls set when the split table is active (overrides all recalls programmed under MM->1->1->2)

• OMT - (phaseOmitted) omit this phase if it is enabled under MM->1->1->2 when the split table is active

• Enb - (other) enable this phase if it is not enabled under MM->1->1->2 when the split table is active