Coordinate - Alt Tables+ (MM->2->6)
Coordinate - Alt Tables+ (MM->2->6)
Hint! - Click on an Alt Tables+ Option to get Help, then return to this screen by typing the "b" key.
<- Pat# Olp.Off:12345678
CIC CNA1 Max2 Dia | ||||||||||||
|
| Olp.Off | Overlaps 1 through 8 may be turned off by pattern. If the overlap is green when the a pattern with this feature enabled becomes active, the overlap will continue to service until it moves through it's yellow clearance to red. At this point, the overlap will remain in red until a pattern is selected where the overlap is not turned off. |
| CIC | This parameter allows you to enable CIC# 1 - 4 for any pattern. CIC is programmed in menu MM->2->3. |
| CNA1 | Call to Non-Actuated 1 can be selected by pattern. CNA1 (or Non-Actuated 1) is programmed on a phase basis in MM->1->1->2. CNA1 allows the phase to respond to the Hold input and was used with external coordination systems (like UTCS) to hold the coordinated phase until the offset yield point in the cycle. This feature is generally not needed for the internal coordination methods used today. |
| Max2 | This feature allows you to select Max2 in place of Max1 whenever the associated pattern is called. You can use this feature with a free pattern (Cycle length = 0") to change the Max setting by pattern which can be varied by time-of-day. Take care in applying this feature with the MAX II setting under MM->1->1->3 because MAX II overrides the Max2 pattern setting called for under this menu. |
| Dia |
This setting
only pertains to the DIAMOND mode. Valid settings for this parameter
are:
|
